APRS Track Direct

My position About ☰

reset

SQ6OXF-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ6OXF-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766811959	536 Count	129 Count	109 Count
1766811058	535 Count	129 Count	109 Count
1766810158	534 Count	129 Count	109 Count
1766809257	533 Count	129 Count	109 Count
1766808356	532 Count	129 Count	109 Count
1766807456	531 Count	129 Count	109 Count
1766806555	530 Count	129 Count	109 Count
1766805654	529 Count	129 Count	109 Count
1766804754	528 Count	129 Count	109 Count
1766803853	527 Count	129 Count	109 Count
1766802952	526 Count	129 Count	109 Count
1766802052	525 Count	129 Count	109 Count
1766801151	524 Count	129 Count	109 Count
1766800250	523 Count	129 Count	109 Count
1766799349	522 Count	129 Count	109 Count
1766798465	521 Count	129 Count	109 Count
1766797564	520 Count	129 Count	109 Count
1766796664	519 Count	129 Count	109 Count
1766795763	518 Count	129 Count	109 Count
1766794862	517 Count	129 Count	109 Count
1766793962	516 Count	129 Count	109 Count
1766793061	515 Count	129 Count	109 Count
1766792160	514 Count	129 Count	109 Count
1766791260	513 Count	129 Count	109 Count
1766790359	512 Count	129 Count	109 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)