APRS Track Direct

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766799683	264 Count	327 Count	108 Count
1766798778	260 Count	321 Count	105 Count
1766797873	256 Count	314 Count	102 Count
1766796969	255 Count	313 Count	102 Count
1766795153	251 Count	307 Count	100 Count
1766794248	250 Count	307 Count	100 Count
1766793344	249 Count	307 Count	100 Count
1766792439	248 Count	307 Count	100 Count
1766791535	247 Count	307 Count	100 Count
1766790630	246 Count	307 Count	100 Count
1766789726	245 Count	307 Count	100 Count
1766788821	244 Count	307 Count	100 Count
1766787917	243 Count	307 Count	100 Count
1766787012	242 Count	307 Count	100 Count
1766786108	241 Count	307 Count	100 Count
1766785203	240 Count	307 Count	100 Count
1766784299	239 Count	307 Count	100 Count
1766783394	238 Count	307 Count	100 Count
1766782490	237 Count	307 Count	100 Count
1766781585	236 Count	307 Count	100 Count
1766780681	235 Count	307 Count	100 Count
1766779776	234 Count	307 Count	100 Count
1766778872	233 Count	307 Count	100 Count
1766777967	232 Count	307 Count	100 Count
1766777063	231 Count	307 Count	100 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)