APRS Track Direct

My position About ☰

reset

EA5IUE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5IUE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1768178560	997 Count	24 Count
1768177957	996 Count	24 Count
1768177354	995 Count	24 Count
1768176751	994 Count	23 Count
1768176148	993 Count	23 Count
1768175545	992 Count	23 Count
1768174942	991 Count	23 Count
1768174339	990 Count	23 Count
1768173736	989 Count	23 Count
1768173132	988 Count	23 Count
1768172529	987 Count	23 Count
1768171926	986 Count	23 Count
1768171323	985 Count	23 Count
1768170831	984 Count	23 Count
1768170228	983 Count	23 Count
1768169625	982 Count	23 Count
1768169022	981 Count	23 Count
1768168418	980 Count	23 Count
1768167815	979 Count	23 Count
1768167212	978 Count	23 Count
1768166609	977 Count	22 Count
1768166006	976 Count	22 Count
1768165403	975 Count	22 Count
1768164800	974 Count	22 Count
1768164197	973 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)