APRS Track Direct

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1766836395	13 Count	2 Count	2 Count
1766834714	1012 Count	131 Count	129 Count
1766833033	999 Count	129 Count	127 Count
1766831353	986 Count	128 Count	126 Count
1766829672	970 Count	126 Count	124 Count
1766827991	957 Count	124 Count	122 Count
1766826310	943 Count	122 Count	120 Count
1766824629	929 Count	120 Count	118 Count
1766822949	914 Count	118 Count	116 Count
1766821518	900 Count	117 Count	115 Count
1766819837	886 Count	115 Count	113 Count
1766818156	872 Count	113 Count	111 Count
1766816475	857 Count	111 Count	109 Count
1766814794	842 Count	109 Count	107 Count
1766813113	828 Count	107 Count	105 Count
1766811433	813 Count	105 Count	103 Count
1766809752	800 Count	104 Count	102 Count
1766808071	786 Count	102 Count	100 Count
1766806390	773 Count	100 Count	98 Count
1766804709	759 Count	98 Count	96 Count
1766803029	745 Count	96 Count	94 Count
1766801348	730 Count	94 Count	92 Count
1766799917	716 Count	93 Count	91 Count
1766798236	701 Count	91 Count	89 Count
1766796555	687 Count	89 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)