APRS Track Direct

My position About ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1766816602	30 Count	539 Count
1766813020	28 Count	506 Count
1766809417	26 Count	466 Count
1766805816	24 Count	430 Count
1766802214	22 Count	399 Count
1766798613	20 Count	362 Count
1766795011	18 Count	328 Count
1766791410	16 Count	289 Count
1766787808	14 Count	254 Count
1766784207	12 Count	217 Count
1766780604	10 Count	185 Count
1766777003	8 Count	150 Count
1766773401	6 Count	112 Count
1766769818	3 Count	69 Count
1766766216	1 Count	30 Count
1766762614	51 Count	1005 Count
1766759013	49 Count	983 Count
1766755411	47 Count	956 Count
1766751810	45 Count	920 Count
1766748208	43 Count	878 Count
1766744607	40 Count	824 Count
1766741005	38 Count	753 Count
1766737404	31 Count	668 Count
1766733802	25 Count	603 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)