APRS Track Direct

My position About ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766800472	199 Count	646 Count	166 Count
1766798671	194 Count	621 Count	162 Count
1766796870	189 Count	596 Count	158 Count
1766795069	184 Count	573 Count	154 Count
1766793268	179 Count	547 Count	150 Count
1766791468	169 Count	521 Count	141 Count
1766789667	164 Count	501 Count	137 Count
1766787866	159 Count	479 Count	133 Count
1766786066	154 Count	452 Count	129 Count
1766784265	146 Count	427 Count	123 Count
1766760871	18 Count	55 Count	17 Count
1766759071	10 Count	30 Count	10 Count
1766757270	291 Count	1036 Count	241 Count
1766755469	262 Count	982 Count	213 Count
1766753668	250 Count	948 Count	202 Count
1766751867	223 Count	897 Count	176 Count
1766750067	199 Count	841 Count	153 Count
1766748266	175 Count	794 Count	131 Count
1766746465	165 Count	744 Count	122 Count
1766744664	157 Count	707 Count	116 Count
1766742864	149 Count	655 Count	109 Count
1766741063	135 Count	604 Count	96 Count
1766739270	119 Count	551 Count	86 Count
1766737470	106 Count	503 Count	78 Count
1766735669	101 Count	479 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)