APRS Track Direct

My position About ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1766791869	92 Count	277 Count
1766790189	91 Count	274 Count
1766788508	90 Count	269 Count
1766786827	89 Count	263 Count
1766785146	88 Count	260 Count
1766783465	87 Count	259 Count
1766781785	86 Count	256 Count
1766780104	85 Count	253 Count
1766778422	84 Count	250 Count
1766776742	83 Count	247 Count
1766775061	82 Count	243 Count
1766773380	81 Count	235 Count
1766771699	79 Count	233 Count
1766770268	75 Count	230 Count
1766768588	74 Count	227 Count
1766766907	73 Count	224 Count
1766765226	72 Count	219 Count
1766763545	71 Count	216 Count
1766761865	70 Count	213 Count
1766760184	69 Count	210 Count
1766758505	68 Count	207 Count
1766756822	67 Count	204 Count
1766755141	66 Count	201 Count
1766753460	65 Count	198 Count
1766751779	64 Count	190 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)