APRS Track Direct

My position About ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766790758	170 Count	890 Count	125 Count
1766789852	164 Count	873 Count	120 Count
1766788947	159 Count	860 Count	116 Count
1766788041	154 Count	844 Count	112 Count
1766787136	149 Count	831 Count	108 Count
1766785326	144 Count	784 Count	105 Count
1766784424	136 Count	762 Count	98 Count
1766783517	129 Count	741 Count	92 Count
1766782614	126 Count	724 Count	90 Count
1766781710	122 Count	707 Count	87 Count
1766780807	118 Count	691 Count	84 Count
1766779904	114 Count	670 Count	81 Count
1766779003	111 Count	655 Count	79 Count
1766778098	106 Count	638 Count	75 Count
1766777191	100 Count	610 Count	70 Count
1766776290	97 Count	579 Count	68 Count
1766775386	92 Count	559 Count	64 Count
1766773575	86 Count	517 Count	60 Count
1766772669	85 Count	492 Count	60 Count
1766771763	79 Count	474 Count	55 Count
1766770859	77 Count	451 Count	54 Count
1766769954	74 Count	430 Count	52 Count
1766769152	66 Count	413 Count	49 Count
1766768252	62 Count	388 Count	46 Count
1766767341	60 Count	367 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)