APRS Track Direct

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766805922	13 Count	290 Count	0 Count
1766804121	12 Count	250 Count	0 Count
1766802320	11 Count	224 Count	0 Count
1766800520	10 Count	196 Count	0 Count
1766798719	9 Count	173 Count	0 Count
1766796918	8 Count	143 Count	0 Count
1766795118	7 Count	113 Count	0 Count
1766793325	2 Count	82 Count	0 Count
1766791524	1 Count	53 Count	0 Count
1766789723	0 Count	25 Count	0 Count
1766787922	60 Count	1030 Count	25 Count
1766786122	59 Count	991 Count	25 Count
1766784321	55 Count	923 Count	22 Count
1766782520	54 Count	873 Count	22 Count
1766780719	53 Count	839 Count	22 Count
1766778919	52 Count	810 Count	22 Count
1766777118	51 Count	787 Count	22 Count
1766775317	50 Count	762 Count	22 Count
1766773517	49 Count	716 Count	22 Count
1766771724	43 Count	665 Count	21 Count
1766769923	42 Count	642 Count	21 Count
1766768122	33 Count	569 Count	13 Count
1766766321	30 Count	544 Count	11 Count
1766764521	29 Count	509 Count	11 Count
1766762720	25 Count	480 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)