APRS Track Direct

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766822152	999 Count	681 Count	680 Count
1766820348	997 Count	680 Count	679 Count
1766818544	995 Count	679 Count	678 Count
1766816740	992 Count	677 Count	676 Count
1766814937	989 Count	675 Count	674 Count
1766813133	986 Count	673 Count	672 Count
1766811330	982 Count	670 Count	669 Count
1766809527	978 Count	667 Count	666 Count
1766807769	974 Count	664 Count	663 Count
1766805966	970 Count	661 Count	660 Count
1766804163	966 Count	658 Count	657 Count
1766802360	962 Count	655 Count	654 Count
1766800556	958 Count	652 Count	651 Count
1766798752	955 Count	650 Count	649 Count
1766796949	951 Count	647 Count	646 Count
1766795144	948 Count	645 Count	644 Count
1766793340	944 Count	642 Count	641 Count
1766791534	941 Count	640 Count	639 Count
1766789731	936 Count	637 Count	636 Count
1766787927	934 Count	636 Count	635 Count
1766786185	932 Count	635 Count	634 Count
1766784381	931 Count	635 Count	634 Count
1766782577	930 Count	635 Count	634 Count
1766780774	929 Count	635 Count	634 Count
1766778971	928 Count	635 Count	634 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)