APRS Track Direct

My position About ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1766805363	5 Count	33 Count	2 Count
1766804163	4 Count	21 Count	2 Count
1766802962	2 Count	15 Count	1 Count
1766801762	1 Count	7 Count	1 Count
1766800561	236 Count	1002 Count	74 Count
1766799360	234 Count	996 Count	73 Count
1766798160	232 Count	987 Count	72 Count
1766796959	231 Count	980 Count	72 Count
1766795758	230 Count	972 Count	72 Count
1766794558	228 Count	964 Count	71 Count
1766793357	227 Count	953 Count	71 Count
1766792157	226 Count	946 Count	71 Count
1766790956	225 Count	938 Count	71 Count
1766789755	224 Count	931 Count	71 Count
1766788555	222 Count	925 Count	70 Count
1766787354	221 Count	912 Count	70 Count
1766786163	216 Count	893 Count	70 Count
1766784963	215 Count	860 Count	70 Count
1766783762	214 Count	832 Count	70 Count
1766782562	212 Count	805 Count	69 Count
1766781361	210 Count	791 Count	68 Count
1766780160	209 Count	778 Count	68 Count
1766778960	208 Count	770 Count	68 Count
1766777759	207 Count	765 Count	68 Count
1766776559	206 Count	757 Count	68 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)