APRS Track Direct

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1766831270	826 Count	168 Count
1766830670	819 Count	167 Count
1766830070	808 Count	166 Count
1766829470	793 Count	164 Count
1766828869	788 Count	164 Count
1766828269	783 Count	164 Count
1766827669	769 Count	163 Count
1766827069	764 Count	162 Count
1766826469	758 Count	162 Count
1766825869	749 Count	160 Count
1766825269	736 Count	159 Count
1766824668	733 Count	159 Count
1766824072	727 Count	158 Count
1766823472	717 Count	157 Count
1766822872	710 Count	157 Count
1766822272	700 Count	156 Count
1766821672	688 Count	155 Count
1766821071	683 Count	155 Count
1766820471	676 Count	154 Count
1766819871	666 Count	153 Count
1766819271	659 Count	153 Count
1766818671	652 Count	152 Count
1766818071	645 Count	151 Count
1766817471	641 Count	151 Count
1766816871	631 Count	150 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)