APRS Track Direct

My position About ☰

reset

SP8C-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766833166	191 Count	112 Count	84 Count
1766832266	191 Count	112 Count	84 Count
1766831366	191 Count	112 Count	84 Count
1766830466	191 Count	112 Count	84 Count
1766829566	191 Count	112 Count	84 Count
1766828666	191 Count	112 Count	84 Count
1766827765	191 Count	112 Count	84 Count
1766826865	191 Count	112 Count	84 Count
1766825965	191 Count	112 Count	84 Count
1766825065	191 Count	112 Count	84 Count
1766824165	191 Count	112 Count	84 Count
1766823265	191 Count	112 Count	84 Count
1766822365	191 Count	112 Count	84 Count
1766821465	191 Count	112 Count	84 Count
1766820565	189 Count	110 Count	82 Count
1766819665	185 Count	106 Count	78 Count
1766818765	181 Count	102 Count	74 Count
1766817865	181 Count	102 Count	74 Count
1766816965	181 Count	102 Count	74 Count
1766816065	181 Count	102 Count	74 Count
1766815165	181 Count	102 Count	74 Count
1766814265	181 Count	102 Count	74 Count
1766813365	181 Count	102 Count	74 Count
1766812465	181 Count	102 Count	74 Count
1766811565	181 Count	102 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)