APRS Track Direct

My position About ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1766829644	4 Count	166 Count
1766828743	0 Count	111 Count
1766827842	34 Count	1127 Count
1766826941	30 Count	996 Count
1766826040	29 Count	885 Count
1766825139	25 Count	812 Count
1766824239	24 Count	664 Count
1766823338	20 Count	596 Count
1766822436	19 Count	496 Count
1766821535	17 Count	484 Count
1766820635	15 Count	391 Count
1766819734	8 Count	283 Count
1766818833	7 Count	265 Count
1766817932	4 Count	226 Count
1766817031	3 Count	117 Count
1766816130	35 Count	1087 Count
1766815230	33 Count	978 Count
1766814329	30 Count	886 Count
1766813427	29 Count	784 Count
1766812526	23 Count	662 Count
1766811625	22 Count	567 Count
1766810724	19 Count	508 Count
1766809824	18 Count	406 Count
1766808922	13 Count	321 Count
1766808021	12 Count	272 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)