APRS Track Direct

My position About ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766806382	439 Count	936 Count	250 Count
1766804588	438 Count	936 Count	250 Count
1766802788	437 Count	936 Count	250 Count
1766800987	436 Count	936 Count	250 Count
1766799186	435 Count	936 Count	250 Count
1766797386	434 Count	936 Count	250 Count
1766795585	433 Count	936 Count	250 Count
1766793784	432 Count	936 Count	250 Count
1766791984	431 Count	936 Count	250 Count
1766790183	430 Count	936 Count	250 Count
1766788382	429 Count	936 Count	250 Count
1766786581	428 Count	936 Count	250 Count
1766784781	427 Count	936 Count	250 Count
1766782987	426 Count	936 Count	250 Count
1766781187	425 Count	936 Count	250 Count
1766779386	424 Count	936 Count	250 Count
1766777585	423 Count	936 Count	250 Count
1766775785	422 Count	936 Count	250 Count
1766773984	421 Count	936 Count	250 Count
1766772183	420 Count	936 Count	250 Count
1766770383	419 Count	936 Count	250 Count
1766768582	418 Count	936 Count	250 Count
1766766781	417 Count	936 Count	250 Count
1766764981	416 Count	936 Count	250 Count
1766763180	415 Count	936 Count	250 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)