APRS Track Direct

My position About ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766849611	75 Count	837 Count
1766847808	74 Count	825 Count
1766846004	73 Count	810 Count
1766844201	72 Count	795 Count
1766842397	71 Count	779 Count
1766840594	70 Count	764 Count
1766838830	65 Count	754 Count
1766837026	64 Count	741 Count
1766835223	63 Count	729 Count
1766833419	62 Count	715 Count
1766831616	61 Count	700 Count
1766829812	60 Count	677 Count
1766828008	59 Count	660 Count
1766826205	58 Count	638 Count
1766824401	57 Count	626 Count
1766822598	56 Count	604 Count
1766820794	55 Count	592 Count
1766818991	54 Count	579 Count
1766817228	49 Count	565 Count
1766815424	48 Count	552 Count
1766813621	47 Count	538 Count
1766811817	46 Count	521 Count
1766810014	45 Count	501 Count
1766808210	44 Count	486 Count
1766806407	43 Count	471 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)