APRS Track Direct

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766811794	29 Count	1002 Count
1766809987	27 Count	958 Count
1766808183	26 Count	914 Count
1766806380	25 Count	872 Count
1766804577	23 Count	807 Count
1766802773	21 Count	762 Count
1766800970	20 Count	712 Count
1766799167	19 Count	666 Count
1766797400	18 Count	616 Count
1766795597	17 Count	544 Count
1766793794	15 Count	504 Count
1766791990	14 Count	484 Count
1766790187	13 Count	442 Count
1766788384	10 Count	397 Count
1766786580	9 Count	351 Count
1766784777	8 Count	309 Count
1766782973	6 Count	259 Count
1766781170	4 Count	216 Count
1766779367	3 Count	163 Count
1766777563	2 Count	113 Count
1766775802	1 Count	58 Count
1766773997	30 Count	1030 Count
1766772194	29 Count	964 Count
1766770391	28 Count	930 Count
1766768587	27 Count	895 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)