APRS Track Direct

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1766799007	189 Count	580 Count	13 Count
1766797326	188 Count	578 Count	13 Count
1766795647	187 Count	575 Count	13 Count
1766793964	186 Count	567 Count	13 Count
1766792284	185 Count	564 Count	13 Count
1766790603	184 Count	562 Count	13 Count
1766788922	183 Count	559 Count	13 Count
1766787241	182 Count	553 Count	13 Count
1766785560	181 Count	549 Count	13 Count
1766783880	180 Count	547 Count	13 Count
1766782199	179 Count	544 Count	13 Count
1766780518	177 Count	541 Count	13 Count
1766779087	173 Count	540 Count	13 Count
1766777406	172 Count	537 Count	13 Count
1766775725	171 Count	534 Count	13 Count
1766774044	170 Count	530 Count	13 Count
1766772363	169 Count	522 Count	13 Count
1766770683	168 Count	519 Count	13 Count
1766769002	167 Count	517 Count	13 Count
1766767321	166 Count	514 Count	13 Count
1766765640	165 Count	511 Count	13 Count
1766763960	164 Count	506 Count	13 Count
1766762279	159 Count	498 Count	9 Count
1766760600	158 Count	495 Count	9 Count
1766758917	147 Count	483 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)