APRS Track Direct

My position About ☰

reset

KQ6DI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1766817367	260	745	683	518	518
1766815567	262	748	686	529	529
1766813766	260	752	689	537	537
1766811967	262	748	684	536	536
1766810167	262	750	687	545	542
1766808367	262	755	691	555	554
1766806567	265	749	686	550	546
1766804767	265	751	688	553	551
1766802966	264	753	690	558	556
1766801167	268	758	692	566	564
1766799367	268	746	689	560	555
1766797567	268	750	689	571	566
1766795767	268	753	692	583	581
1766793968	268	756	695	612	605
1766792168	274	759	697	628	619
1766790367	312	763	698	645	635
1766788567	284	763	700	640	630
1766786767	304	767	702	652	638
1766784967	283	756	694	646	629
1766783166	292	758	696	664	643
1766781367	304	758	696	692	665
1766779568	321	760	697	691	660
1766777767	351	760	697	678	651
1766775967	323	760	698	663	641
1766774167	362	762	698	653	632

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)