APRS Track Direct

My position About ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766812019	359 Count	210 Count	190 Count
1766810218	357 Count	209 Count	189 Count
1766808418	355 Count	208 Count	188 Count
1766806617	354 Count	208 Count	188 Count
1766804823	348 Count	207 Count	187 Count
1766803022	346 Count	206 Count	186 Count
1766801222	344 Count	205 Count	185 Count
1766799421	342 Count	204 Count	184 Count
1766797621	340 Count	203 Count	183 Count
1766795820	338 Count	202 Count	182 Count
1766794019	336 Count	201 Count	181 Count
1766792219	334 Count	200 Count	180 Count
1766790418	333 Count	200 Count	180 Count
1766788618	331 Count	199 Count	179 Count
1766786817	329 Count	198 Count	178 Count
1766785016	327 Count	197 Count	177 Count
1766783223	321 Count	196 Count	176 Count
1766781422	319 Count	195 Count	175 Count
1766779622	317 Count	194 Count	174 Count
1766777821	315 Count	193 Count	173 Count
1766776021	313 Count	192 Count	172 Count
1766774219	311 Count	191 Count	171 Count
1766772419	303 Count	184 Count	164 Count
1766770619	300 Count	182 Count	162 Count
1766768817	298 Count	181 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)