APRS Track Direct

My position About ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766819369	318 Count	802 Count
1766817566	317 Count	801 Count
1766815763	316 Count	800 Count
1766813960	315 Count	799 Count
1766812157	314 Count	797 Count
1766810354	313 Count	795 Count
1766808587	312 Count	793 Count
1766806784	311 Count	791 Count
1766804981	310 Count	790 Count
1766803178	309 Count	789 Count
1766801375	308 Count	789 Count
1766799572	307 Count	788 Count
1766797768	306 Count	788 Count
1766795965	305 Count	788 Count
1766794162	304 Count	788 Count
1766792359	303 Count	788 Count
1766790556	302 Count	787 Count
1766788753	301 Count	787 Count
1766786987	300 Count	787 Count
1766785184	299 Count	787 Count
1766783380	298 Count	787 Count
1766781577	297 Count	787 Count
1766779774	296 Count	787 Count
1766777971	295 Count	787 Count
1766776168	294 Count	787 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)