APRS Track Direct

My position About ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766817707	3 Count	411 Count
1766815903	2 Count	297 Count
1766814100	1 Count	181 Count
1766812296	0 Count	71 Count
1766810493	15 Count	1013 Count
1766808689	14 Count	964 Count
1766806886	13 Count	902 Count
1766805082	12 Count	843 Count
1766803279	11 Count	783 Count
1766801475	10 Count	725 Count
1766799706	9 Count	670 Count
1766797903	8 Count	618 Count
1766796099	7 Count	557 Count
1766794296	6 Count	492 Count
1766792492	5 Count	434 Count
1766790688	4 Count	378 Count
1766788885	3 Count	288 Count
1766787081	2 Count	159 Count
1766785278	1 Count	59 Count
1766783474	0 Count	0 Count
1766781705	9 Count	988 Count
1766779902	8 Count	935 Count
1766778098	7 Count	841 Count
1766776295	6 Count	699 Count
1766774491	5 Count	582 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)