APRS Track Direct

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766806940	20 Count	303 Count
1766805139	19 Count	291 Count
1766803338	18 Count	279 Count
1766801538	17 Count	267 Count
1766799737	16 Count	254 Count
1766797936	15 Count	242 Count
1766796136	14 Count	229 Count
1766794335	13 Count	217 Count
1766792542	12 Count	205 Count
1766790741	11 Count	193 Count
1766788940	10 Count	181 Count
1766787140	9 Count	169 Count
1766785339	8 Count	157 Count
1766783538	7 Count	145 Count
1766781737	6 Count	128 Count
1766779937	5 Count	91 Count
1766778136	4 Count	71 Count
1766776335	3 Count	45 Count
1766774535	2 Count	25 Count
1766772734	0 Count	0 Count
1766770941	71 Count	981 Count
1766769140	64 Count	950 Count
1766767340	63 Count	930 Count
1766765539	62 Count	910 Count
1766763738	61 Count	893 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)