APRS Track Direct

My position About ☰

reset

SQ8XY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8XY-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766790774	153 Count	628 Count	95 Count
1766788977	150 Count	619 Count	93 Count
1766787177	148 Count	615 Count	92 Count
1766785376	145 Count	604 Count	90 Count
1766783576	139 Count	587 Count	85 Count
1766781775	136 Count	580 Count	83 Count
1766779974	133 Count	570 Count	81 Count
1766778174	130 Count	560 Count	79 Count
1766776373	128 Count	545 Count	78 Count
1766774572	123 Count	531 Count	74 Count
1766772772	119 Count	520 Count	71 Count
1766770971	116 Count	506 Count	69 Count
1766769170	112 Count	492 Count	66 Count
1766767378	108 Count	473 Count	63 Count
1766765577	105 Count	454 Count	61 Count
1766763777	100 Count	436 Count	57 Count
1766761976	95 Count	402 Count	53 Count
1766760175	92 Count	372 Count	51 Count
1766758375	85 Count	340 Count	45 Count
1766756574	79 Count	311 Count	40 Count
1766754773	76 Count	290 Count	38 Count
1766752973	70 Count	273 Count	33 Count
1766751172	68 Count	245 Count	32 Count
1766749371	64 Count	222 Count	29 Count
1766747571	60 Count	198 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)