APRS Track Direct

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766819607	167 Count	315 Count
1766817806	166 Count	313 Count
1766816005	165 Count	311 Count
1766814205	164 Count	309 Count
1766812404	163 Count	308 Count
1766810610	162 Count	306 Count
1766808809	161 Count	304 Count
1766807008	160 Count	302 Count
1766805208	159 Count	300 Count
1766803407	158 Count	298 Count
1766801606	157 Count	296 Count
1766799805	156 Count	294 Count
1766798005	155 Count	292 Count
1766796204	154 Count	290 Count
1766794403	153 Count	288 Count
1766792603	152 Count	286 Count
1766790802	151 Count	284 Count
1766789010	150 Count	282 Count
1766787209	149 Count	280 Count
1766785408	148 Count	278 Count
1766783608	147 Count	276 Count
1766781807	146 Count	275 Count
1766780006	145 Count	273 Count
1766778205	144 Count	272 Count
1766776405	143 Count	270 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)