APRS Track Direct

My position About ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1766823289	271 Count	960 Count	205 Count
1766817886	255 Count	920 Count	192 Count
1766816086	252 Count	906 Count	190 Count
1766810684	235 Count	852 Count	176 Count
1766808883	230 Count	837 Count	172 Count
1766807083	227 Count	827 Count	170 Count
1766803488	216 Count	804 Count	165 Count
1766798086	205 Count	761 Count	157 Count
1766796285	200 Count	750 Count	153 Count
1766794485	195 Count	731 Count	149 Count
1766792684	190 Count	714 Count	145 Count
1766774684	135 Count	604 Count	104 Count
1766772884	130 Count	592 Count	100 Count
1766771083	126 Count	583 Count	97 Count
1766767482	111 Count	553 Count	84 Count
1766753083	63 Count	284 Count	48 Count
1766751283	58 Count	260 Count	44 Count
1766747682	49 Count	223 Count	37 Count
1766738685	19 Count	157 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)