APRS Track Direct

My position About ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766804959	275 Count	710 Count	73 Count
1766803158	274 Count	708 Count	73 Count
1766801358	273 Count	706 Count	73 Count
1766799556	272 Count	704 Count	73 Count
1766797756	271 Count	702 Count	73 Count
1766795955	270 Count	700 Count	73 Count
1766794154	269 Count	698 Count	73 Count
1766792360	268 Count	696 Count	73 Count
1766790560	267 Count	695 Count	73 Count
1766788759	266 Count	693 Count	73 Count
1766786959	265 Count	691 Count	73 Count
1766785158	264 Count	689 Count	73 Count
1766783357	263 Count	682 Count	73 Count
1766781556	262 Count	680 Count	73 Count
1766779756	261 Count	678 Count	73 Count
1766777955	260 Count	676 Count	73 Count
1766776155	259 Count	674 Count	73 Count
1766774354	258 Count	672 Count	73 Count
1766772553	251 Count	658 Count	67 Count
1766770761	248 Count	653 Count	65 Count
1766768960	247 Count	651 Count	65 Count
1766767160	246 Count	649 Count	65 Count
1766765359	245 Count	647 Count	65 Count
1766763558	244 Count	645 Count	65 Count
1766761758	243 Count	638 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)