APRS Track Direct

My position About ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766805461	157 Count	522 Count	134 Count
1766803661	146 Count	496 Count	124 Count
1766801860	140 Count	476 Count	119 Count
1766800060	134 Count	453 Count	114 Count
1766798259	128 Count	430 Count	109 Count
1766796458	122 Count	410 Count	104 Count
1766794658	116 Count	384 Count	99 Count
1766792857	110 Count	362 Count	94 Count
1766791056	103 Count	341 Count	88 Count
1766789256	97 Count	321 Count	83 Count
1766787455	91 Count	294 Count	78 Count
1766785655	82 Count	270 Count	70 Count
1766783862	76 Count	252 Count	65 Count
1766782061	66 Count	226 Count	56 Count
1766780260	60 Count	205 Count	51 Count
1766778460	54 Count	183 Count	46 Count
1766776659	48 Count	160 Count	41 Count
1766774858	41 Count	136 Count	35 Count
1766773058	35 Count	110 Count	30 Count
1766771257	28 Count	84 Count	24 Count
1766769456	21 Count	62 Count	18 Count
1766767656	14 Count	40 Count	12 Count
1766765855	8 Count	20 Count	7 Count
1766764054	0 Count	0 Count	0 Count
1766762261	237 Count	996 Count	185 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)