APRS Track Direct

My position About ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766802284	86 Count	444 Count	43 Count
1766798682	80 Count	419 Count	40 Count
1766793879	70 Count	390 Count	34 Count
1766789076	63 Count	340 Count	31 Count
1766787887	56 Count	330 Count	29 Count
1766783084	48 Count	314 Count	25 Count
1766779482	43 Count	291 Count	23 Count
1766775880	37 Count	257 Count	20 Count
1766772278	31 Count	234 Count	17 Count
1766767475	21 Count	146 Count	11 Count
1766766286	14 Count	128 Count	9 Count
1766765085	12 Count	112 Count	8 Count
1766761483	5 Count	53 Count	4 Count
1766757881	129 Count	999 Count	91 Count
1766754279	95 Count	896 Count	60 Count
1766749476	70 Count	755 Count	39 Count
1766745874	62 Count	692 Count	34 Count
1766743486	54 Count	649 Count	32 Count
1766739882	47 Count	579 Count	28 Count
1766738683	44 Count	554 Count	26 Count
1766736282	36 Count	487 Count	20 Count
1766735082	33 Count	449 Count	18 Count
1766733881	30 Count	414 Count	16 Count
1766732680	28 Count	372 Count	15 Count
1766731479	26 Count	344 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)