APRS Track Direct

My position About ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1766821494	91 Count	381 Count
1766817907	90 Count	379 Count
1766814304	89 Count	377 Count
1766810701	88 Count	375 Count
1766807098	87 Count	373 Count
1766803495	86 Count	371 Count
1766799892	85 Count	364 Count
1766796306	84 Count	362 Count
1766792703	83 Count	360 Count
1766789100	82 Count	358 Count
1766785497	81 Count	356 Count
1766781894	80 Count	354 Count
1766778291	79 Count	347 Count
1766774706	78 Count	345 Count
1766771104	77 Count	343 Count
1766767501	76 Count	341 Count
1766763898	75 Count	339 Count
1766760295	74 Count	338 Count
1766756692	73 Count	288 Count
1766753105	72 Count	250 Count
1766749502	71 Count	248 Count
1766745899	70 Count	220 Count
1766742296	69 Count	197 Count
1766738693	68 Count	195 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)