APRS Track Direct

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766776484	43 Count	432 Count
1766774683	42 Count	429 Count
1766772881	41 Count	426 Count
1766771085	40 Count	423 Count
1766769283	39 Count	420 Count
1766767482	38 Count	417 Count
1766765681	37 Count	414 Count
1766763884	36 Count	411 Count
1766762083	35 Count	408 Count
1766760282	34 Count	404 Count
1766758480	33 Count	400 Count
1766756684	32 Count	395 Count
1766754882	31 Count	390 Count
1766753081	30 Count	384 Count
1766751280	29 Count	380 Count
1766749483	28 Count	352 Count
1766747682	27 Count	349 Count
1766745881	26 Count	346 Count
1766744079	25 Count	343 Count
1766742284	24 Count	340 Count
1766740483	23 Count	337 Count
1766738681	22 Count	334 Count
1766736880	21 Count	331 Count
1766735083	20 Count	328 Count
1766733281	19 Count	325 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)