APRS Track Direct

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766825652	66 Count	565 Count	52 Count
1766824751	62 Count	527 Count	49 Count
1766823850	59 Count	487 Count	47 Count
1766822950	54 Count	446 Count	43 Count
1766822049	53 Count	438 Count	43 Count
1766821148	49 Count	398 Count	40 Count
1766820248	44 Count	349 Count	36 Count
1766819347	38 Count	308 Count	31 Count
1766818446	33 Count	269 Count	27 Count
1766817546	27 Count	227 Count	22 Count
1766816645	24 Count	189 Count	20 Count
1766815744	19 Count	153 Count	16 Count
1766814844	15 Count	119 Count	13 Count
1766813943	9 Count	79 Count	8 Count
1766813042	5 Count	43 Count	5 Count
1766812142	136 Count	1034 Count	99 Count
1766811241	131 Count	996 Count	95 Count
1766810340	129 Count	968 Count	94 Count
1766809440	125 Count	929 Count	91 Count
1766808555	116 Count	892 Count	87 Count
1766807654	111 Count	851 Count	83 Count
1766806753	106 Count	814 Count	79 Count
1766805853	102 Count	769 Count	76 Count
1766804952	96 Count	734 Count	71 Count
1766804051	91 Count	697 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)