APRS Track Direct

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766789982	156 Count	503 Count	149 Count
1766788181	136 Count	444 Count	130 Count
1766786379	117 Count	379 Count	112 Count
1766784579	98 Count	316 Count	94 Count
1766782777	79 Count	253 Count	76 Count
1766780975	62 Count	195 Count	60 Count
1766779175	41 Count	131 Count	40 Count
1766777373	20 Count	67 Count	20 Count
1766775571	215 Count	1024 Count	203 Count
1766773770	196 Count	959 Count	185 Count
1766771968	177 Count	862 Count	167 Count
1766770168	157 Count	751 Count	149 Count
1766768366	143 Count	645 Count	136 Count
1766764764	109 Count	482 Count	104 Count
1766762963	90 Count	401 Count	86 Count
1766761162	73 Count	327 Count	70 Count
1766759361	54 Count	232 Count	52 Count
1766757560	35 Count	165 Count	34 Count
1766755759	16 Count	74 Count	16 Count
1766753957	240 Count	1007 Count	215 Count
1766752157	223 Count	940 Count	199 Count
1766750359	203 Count	866 Count	180 Count
1766748555	184 Count	789 Count	162 Count
1766746771	152 Count	665 Count	135 Count
1766744971	132 Count	554 Count	117 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)