APRS Track Direct

My position About ☰

reset

SP8KZI-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KZI-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767457165	315 Count	636 Count	210 Count
1767455361	310 Count	612 Count	206 Count
1767453562	306 Count	584 Count	203 Count
1767451760	300 Count	556 Count	198 Count
1767449959	296 Count	548 Count	195 Count
1767448158	292 Count	517 Count	192 Count
1767444562	275 Count	443 Count	181 Count
1767442762	271 Count	402 Count	178 Count
1767440961	267 Count	388 Count	175 Count
1767437359	259 Count	375 Count	169 Count
1767435558	255 Count	367 Count	166 Count
1767433757	252 Count	360 Count	164 Count
1767424753	229 Count	321 Count	147 Count
1767423406	223 Count	314 Count	145 Count
1767421606	218 Count	304 Count	141 Count
1767419805	214 Count	296 Count	138 Count
1767418016	206 Count	289 Count	135 Count
1767416216	202 Count	283 Count	132 Count
1767414412	197 Count	275 Count	128 Count
1767412612	193 Count	269 Count	125 Count
1767410811	189 Count	261 Count	122 Count
1767409009	184 Count	252 Count	118 Count
1767407208	180 Count	244 Count	115 Count
1767405407	175 Count	235 Count	111 Count
1767403606	171 Count	227 Count	108 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)