APRS Track Direct

My position About ☰

reset

KQ6DI-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1766779445	1207	725	365	716	59
1766778870	1204	721	354	712	67
1766778526	1205	714	354	707	63
1766778149	1205	714	354	707	62
1766777430	1205	707	349	702	64
1766776710	1209	701	343	694	63
1766776390	1205	699	349	694	67
1766775990	1220	698	343	694	68
1766775270	1204	698	343	689	67
1766774590	1209	697	343	689	67
1766774550	1205	697	343	689	67
1766773830	1204	697	343	689	67
1766773110	1205	696	343	689	68
1766772790	1204	696	343	689	67
1766772390	1205	695	343	684	68
1766771671	1205	695	338	684	67
1766770990	1205	695	343	684	67
1766770950	1205	695	343	684	67
1766770230	1209	695	343	684	67
1766769510	1205	695	343	689	65
1766769189	1205	695	343	684	66
1766768791	1205	695	343	689	65
1766768070	1205	695	343	684	66
1766767390	1205	694	343	684	65
1766767349	1205	694	338	684	67

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)