APRS Track Direct

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766823642	213 Count	341 Count	159 Count
1766822742	211 Count	336 Count	158 Count
1766821841	209 Count	332 Count	157 Count
1766820940	207 Count	327 Count	156 Count
1766820039	205 Count	324 Count	155 Count
1766819138	203 Count	319 Count	154 Count
1766818237	201 Count	313 Count	153 Count
1766817337	199 Count	303 Count	152 Count
1766816436	197 Count	299 Count	151 Count
1766815535	195 Count	295 Count	150 Count
1766814634	190 Count	287 Count	146 Count
1766813734	185 Count	280 Count	142 Count
1766812833	180 Count	273 Count	138 Count
1766811932	175 Count	265 Count	134 Count
1766811032	171 Count	258 Count	131 Count
1766810131	168 Count	253 Count	129 Count
1766809230	165 Count	248 Count	127 Count
1766808329	164 Count	248 Count	127 Count
1766807429	162 Count	244 Count	126 Count
1766806528	160 Count	236 Count	125 Count
1766805627	157 Count	231 Count	123 Count
1766804727	155 Count	226 Count	122 Count
1766803843	149 Count	221 Count	121 Count
1766802942	147 Count	216 Count	120 Count
1766802041	145 Count	212 Count	119 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)