APRS Track Direct

My position About ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767199782	31 Count	430 Count	29 Count
1767197982	18 Count	275 Count	17 Count
1767196181	9 Count	122 Count	9 Count
1767194381	65 Count	1012 Count	57 Count
1767192580	54 Count	796 Count	47 Count
1767190779	46 Count	619 Count	40 Count
1767188979	38 Count	529 Count	33 Count
1767187178	31 Count	429 Count	27 Count
1767185378	23 Count	346 Count	20 Count
1767183577	15 Count	254 Count	13 Count
1767183191	14 Count	254 Count	13 Count
1767181391	7 Count	121 Count	7 Count
1767179590	66 Count	1012 Count	59 Count
1767177789	55 Count	886 Count	49 Count
1767175995	48 Count	786 Count	43 Count
1767174195	40 Count	684 Count	36 Count
1767172394	31 Count	574 Count	28 Count
1767170593	23 Count	491 Count	21 Count
1767168793	18 Count	346 Count	17 Count
1767166992	7 Count	157 Count	7 Count
1767165192	108 Count	1112 Count	97 Count
1767163391	92 Count	992 Count	82 Count
1767161591	84 Count	832 Count	75 Count
1767159790	74 Count	744 Count	66 Count
1767157989	66 Count	682 Count	59 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)