APRS Track Direct

My position About ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766818255	51 Count	256 Count
1766816454	50 Count	251 Count
1766814653	49 Count	246 Count
1766812853	48 Count	239 Count
1766811052	47 Count	235 Count
1766809251	46 Count	230 Count
1766807450	45 Count	225 Count
1766805650	44 Count	219 Count
1766803856	43 Count	215 Count
1766802056	42 Count	210 Count
1766800255	41 Count	206 Count
1766798454	40 Count	201 Count
1766796654	39 Count	197 Count
1766794853	38 Count	193 Count
1766793052	37 Count	188 Count
1766791252	36 Count	183 Count
1766789451	35 Count	178 Count
1766787650	34 Count	173 Count
1766785849	33 Count	170 Count
1766784049	32 Count	163 Count
1766782256	31 Count	159 Count
1766780455	30 Count	155 Count
1766778655	29 Count	150 Count
1766776854	28 Count	144 Count
1766775053	27 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)